Bio-Signal Filtering and Noise Exploration
Compare raw and filtered ECG or PPG samples and observe how smoothing changes timing and peaks. Begin with recorded sample data before live sensor experiments. Education only, not for diagnosis or health decisions. Body-connected ECG work requires battery-only equipment disconnected from chargers, mains-powered peripherals and test instruments. Verified wiring and tested code are still pending.
What you build in this project
Bio-Signal Filtering and Noise Exploration is one focused build from the Biomedical Sensor & Bio-Signal Learning Kit. It uses the parts listed below to make a working electronics example, then you can combine it with the other projects in the kit.
Compare raw and filtered ECG or PPG samples and observe how smoothing changes timing and peaks. Begin with recorded sample data before live sensor experiments. Education only, not for diagnosis or health decisions. Body-connected ECG work requires battery-only equipment disconnected from chargers, mains-powered peripherals and test instruments. Verified wiring and tested code are still pending.
Parts used
ESP32U, AD8232, MAX30102, Breadboard, Jumper wires
What to check
Wire the parts, upload the sketch from the kit page, then test this project by watching the Serial Monitor or the output behavior.
What you learn
You learn how the controller reads real sensor signals, makes a decision in code, and turns that result into a useful output.
What this project uses
Every item is in the kit — nothing extra to buy.
Biomedical Sensor & Bio-Signal Learning Kit
All 6 parts in one box, with this project and 7 more to build from them.
Need only these parts? Order them loose · from AED 117.94
One of each part. Packs (resistor assortment, jumper wires) already hold more than a single build needs. Delivery is free on orders AED 150.00+.
More from this kit
ESP32 Raw ECG Signal Acquisition
Read the AD8232 analog output with ESP32 and study sampled values. The AD8232 pack includes the three-lead cable and electrode pads. Education only, not for diagnosis or…
ESP32 ECG Waveform in Arduino Serial Plotter
Plot AD8232 samples in Arduino Serial Plotter with the complimentary USB-A to USB-C data cable. While electrodes are attached, run the laptop on battery only with charge…
AD8232 Disconnected Electrode Detection
Read the AD8232 leads-off outputs and report an electrode-connection warning instead of displaying a misleading signal. Connection status is not health status. Education…