Project 7 of 7 Network

Future Wi-Fi dashboard

Add networking only after the USB/Serial build is stable. Keep credentials out of shared code and review privacy, reconnection behavior, power, enclosure, and unattended-operation risks. No cloud service or dashboard is included.

One of 7 projects in the ESP32 Plant Monitoring Learning Kit — the parts below are from that kit.

// How it works

What you build in this project

Future Wi-Fi dashboard is one focused build from the ESP32 Plant Monitoring Learning Kit. It uses the parts listed below to make a working electronics example, then you can combine it with the other projects in the kit.

Add networking only after the USB/Serial build is stable. Keep credentials out of shared code and review privacy, reconnection behavior, power, enclosure, and unattended-operation risks. No cloud service or dashboard is included.

Parts used

Completed local main build and user-supplied Wi-Fi network

What to check

Wire the parts, upload the sketch from the kit page, then test this project by watching the Serial Monitor or the output behavior.

What you learn

You learn how the controller reads real sensor signals, makes a decision in code, and turns that result into a useful output.

// Items used

What this project uses

Every item is in the kit — nothing extra to buy.

Completed local main build and user-supplied Wi-Fi network

In the kit

Basics Transparent 830 Points Solderless Breadboard Clear Prototype Circuit Board MB-102 High Quality DIY Electronic… DIY-295

In the kit

Basics Jumper Wire Assorted Pack 120 Pieces - Male-to-Male, Male-to-Female, Female-to-Female 10cm Ribbon Cables for… DIY-212

In the kit

Build this with

ESP32 Plant Monitoring Learning Kit

All 7 parts in one box, with this project and 6 more to build from them.

AED 79.00 See the kit

Need only these parts? Order them loose · from AED 40.77

Used in this project tick what you still need

Also needed untick if you already have them

Basics Transparent 830 Points Solderless Breadboard Clear Prototype Circuit Board MB-102 High Quality DIY Electronic… DIY-295 · ×1

AED 15.75

In stock

Basics Jumper Wire Assorted Pack 120 Pieces - Male-to-Male, Male-to-Female, Female-to-Female 10cm Ribbon Cables for… DIY-212 · ×1

AED 25.02

In stock

Selected parts AED 40.77

One of each part. Packs (resistor assortment, jumper wires) already hold more than a single build needs. Completed local main build and user-supplied Wi-Fi network: included in the kit, ask us for it loose. Delivery is AED 20, free on orders AED 150+.

// Keep going

More from this kit

← Previous · 06Optional audible-alert investigation

Sensing 01

Calibrated plant-monitoring lab

Build the reviewed main project, capture four local calibration endpoints, and stream soil, water, temperature, humidity, pressure, and status data to Serial Monitor. Th…

Uses

ESP32U DIY-002 capacitive soil sensor DIY-025 water sensor DIY-018 BME280 full-size breadboard jumper wires

Parts, guide & add to cart →

Sensing 02

Soil-moisture calibration study

Compare raw ADC readings across documented dry, damp, and wet samples of one soil type. Repeat probe depth and compaction, graph the results, and explain why the percent…

Uses

ESP32U DIY-002 capacitive soil sensor breadboard jumper wires user-supplied dry and wet soil references

Parts, guide & add to cart →

Sensing 03

Short-duration water-level experiment

Mark several safe test depths, energize only long enough to record stable readings, then power down, rinse, and dry the tracks. Study repeatability and corrosion risk; d…

Uses

ESP32U DIY-025 conductive water sensor breadboard jumper wires user-supplied shallow non-metallic container and clean water

Parts, guide & add to cart →

All projects →